How to install cold storage

Hello dear consumer brother, we understand that we have bought a good cold storage while paying the electricity bills. We can explain this as follows, in fact, if the cold storage is very well insulated, it works for about 6 hours in 1 day.

6 x 30 180 hours 180 x motor power electricity bill is revealed. This electricity bill shows that the heat insulation of our cold room is good.

The electricity bill that comes above this is a serious situation.

Cold storage part formations

- Cold room chiller group

- Cold room 42 density interlocking sandwich panels.

- Cold room paywood floor panel.

- Cold room isothermal door

- Interior and exterior accessories.

- Polyurethane Foam silicone pop Rivet.

The most important note: my dear consumer brother, if Usta, who came for our assembly, cuts the cold room panels with something other than a chipboard cutting machine, do not have that job done.

Since it is 0-50 mm sheet metal and Polyurethane Foam, the best cutting method is a chipboard cutting machine and a panel cutting knife suitable for it.

For smooth cutting of the panel, the machine has a strip rail. This enables the panel to be cut metrically.

Cold storage installation ends with the installation of external accessories. Never use screws other than painted rivets in cold room installation. The screw is easy for the master, but it rusts forward, leaves the connection, and causes infection.

Keep following us, best regards...

Arama formu

How to install cold storage

Top News