How to make
cold storage How to design cold storage.
storage designs start, the ground determination of the place where the cold room will be established is investigated, the geological features of the ground are investigated and the project is prepared accordingly, the
floor water drains, sewerage and sanitary installation works are carried out together with the concrete system.
During the concrete casting, the Steel Construction connection scissors are placed in the concrete, the concrete is poured and it is expected to dry.
After the concrete casting is finished, the roof covering is completed together with the steel construction.
According to the project, the loading areas of the cold storage, the load carrying corridors are re-checked, the building's outer panel is covered, and the project continues in accordance with the cold storage of the building.
, which are ordered according to the height of the warehouse, is cold room locked sandwich panels assembly
Ceiling suspension systems are used in ceiling panels because cold storage rooms are high and large.
Accessory and silicone works are completed by leaving the door gaps during the placement of the ceiling and wall panels.
cooling requirement , and the door sizes needed must be suitable for the working conditions of the forklift.
panel works have been completed cold storage floor insulation What does the
floor insulation is provided with at least 15 cm of XPS insulation material. In such systems, the sheets at the connection points of the panels with XPS are kept short to create a 15 cm thermal bridge during panel production.
The cold storage, the insulation of which is completed with XPS, is 8 millimeters thick, and the concrete casting is completed with a 15 cm thick iron mesh connected to it with a 10 square system.
The doors of the cold rooms where concrete is cast are assembled according to the dimensions and this process is completed.
of Cooling Systems , ceiling type cooler evaporators are hung in their places.
If needed, a balancing valve is installed in each room separately.
After the cooling and lighting processes are completed, the floor is usually covered with epoxy and then the last situation inside is completed.
After the assembly of the Bellows made for vehicle loading of the loading areas, landscaping is done and the Cold Rooms are made ready for use.
During the landscaping, water channels, water drains and rain water connections are made for the disposal of wastewater.
such enterprises usually have their own energy transformers.
again, such enterprises work with -18 central systems and plus 5 central systems.