8 Tips For Proper Cleaning Your Cold Room

HOW TO CLEAN COLD ROOM PANELS?

Cold rooms are places where you can store and process food and drinks. As a result, a cold room tends to be very quickly contaminated and contaminated by bacteria. In most cases, cold rooms are made of metal-insulated panels. In this blog post, we will provide information on how to clean cold room panels and how to avoid damaging the surface of the insulated metal panel.

COATING OF COOLING PANELS

The metal sheet of these insulated panels can be:

1- Polyester coating;

2- PVDF coating;

3- Plastisol coating;

4- PET coating;

5- It can be made of stainless steel (INOX).

Each of these coatings has a different chemical composition and different recommended uses. The most standard one is Polyester coating.

When maintaining a cold room, it is important to clean and disinfect the surface of the insulated sandwich panel without damaging it.

Unfortunately, in most cases, the staff in charge is not properly informed, so it can damage the coating, which can cause oxidation of the insulated panel.

Therefore, I decided to make a mistake in this article and write a small guide that can prevent you from damaging the insulated sandwich panel and ultimately your cold room.

TOP 11 TIPS TO FOLLOW METAL INSULATED PANEL WHILE CLEANING THE SURFACE:

1- Always clean the surfaces from top to bottom.

2- Rinse the surface thoroughly with clean water;

3- Add the right amount of cleanser to the hot water, do not exceed the recommended amount and dilute;

4- The pH of the cleaner should be between 4 and 9;

5- High pressure cleaning should not be done very close to or vertical to the surface of the metal insulated panel. When using an electric washer, adhere to the following guidelines: 5.1. Maximum 50 bar 30 cm from the panel surface; 5.2. Generally adhere to application temperatures of maximum 30 to 50 ° C; 5.3. In joints, the high pressure cleaner should be directed downwards to prevent water from entering the joints.

6- Do not leave the washing solution in contact with the metal sandwich panel surface for more than 5 minutes;

7- Remove any remaining dirt by using a non-abrasive cleaner; Rinse with clean water.

8- Do not use cleaning products or related products containing chlorine; Never mix different cleaning products;

9 - If you use a higher concentration of cleaner than recommended, this may cause damage to the surface of the metal insulated panel, which can damage oxidation and your cold room;

10 - Excessive cleaning may damage the finish.

11 - Using steam cleaner can damage the coating due to high temperature.

Remember, water is a scarce resource, so use it wisely and don't waste it!

CONTACT US

For more information about cleaning your cold room and how to clean cold room panels, you can contact +90 216 311 36 57. You can also contact us via info@keskinso.com or by filling out the contact form below. After reaching out, we can give you a free quote and also discuss our products and services further.

Arama formu

8 Tips For Proper Cleaning Your Cold Room

Top News